ملف صلب مقاوم للصدأ 304 مدرفل على الساخن No.1

Typical applications

Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.

• Chemical plant — tank shells, reactor jackets, pipe supports
• Water and environment — waste water basin liners, desulphurisation towers, desalination lines
• Industrial structures — walkways, silos, conveyor frames
• Power — flue ducts, heat recovery units
• Further processing — feedstock for cold rolling, or decoiled into plate

Selection FAQ

Can No.1 finish be used as-is?

Yes, but it is grey and rougher. Visible structural parts are usually pickled or brushed afterwards.

Hot rolled or cold rolled coil?

Thicker material (generally above 3 mm), strength first, appearance secondary — hot rolled. Thin gauge, tight tolerance, good surface — cold rolled.